HYBRID BATTERY SYSTEM > CHECK FOR INTERMITTENT PROBLEMS

for Preparation Click here

1. Perform a simulation test (Click here).
   
   

   1. For the simulation test, reproduce the driving conditions that were present when the trouble occurred. These conditions should be based on the customer's comments and freeze frame data that is recorded with DTCs, such as the opening angle of the accelerator pedal, SOC (state of charge), engine coolant temperature, engine rpm, and MG1/MG2 rpm and torque.
      

2. Check the connector(s) and terminal(s) (Click here).
   

3. Wiggle the harness and connector(s) (Click here).
   

4. Heat or cool suspected parts (Click here).