Home

Toyota Workshop

GSIC - Global Service Information Center

DOOR CONTROL RELAY > INSTALLATION

for Preparation Click here



1. INSTALL DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY


    B229276

  1. Install the double lock door control relay assembly with the bolt.

  1. Connect the connector.



2. INSTALL RADIO TUNER OPENING COVER WITH BRACKET (w/o Radio Receiver)


    B223593

  1. Install the radio tuner opening cover with bracket with the 4 bolts <B>.



3. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Radio Receiver)


    B227341

  1. Engage the 4 claws to install the center instrument cluster finish panel sub-assembly.



4. INSTALL RADIO RECEIVER WITH BRACKET (w/ Radio Receiver)

  1. Connect each connector.



    E188510

  1. Engage the 4 claws as shown in the illustration.



    E188506

  1. Install the radio receiver with bracket with the 4 bolts.



5. INSTALL NAVIGATION RECEIVER WITH BRACKET (w/ Navigation System)


    E188508

  1. Engage the 4 claws to temporarily install the navigation receiver assembly with bracket as shown in the illustration.



    E188505

  1. Install the navigation receiver assembly with bracket with the 4 bolts.



6. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B223459

  1. Connect the connector.

  1. Engage the 3 claws to install the upper instrument panel finish panel sub-assembly.



7. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH

  1. Connect the connector.



  1. Engage the 14 claws to install the instrument cluster finish panel garnish.


    B223458



8. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B223456

  1. Engage the 7 claws and 2 clips to install the lower center instrument cluster finish panel sub-assembly.



9. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY


    B223453

  1. Connect each connector.

  1. Engage the 6 claws to install the integration control and panel assembly.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).