Home

Toyota Workshop

GSIC - Global Service Information Center

SKID CONTROL BUZZER (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL SKID CONTROL BUZZER ASSEMBLY


    C208056

  1. Connect the skid control buzzer connector.

  1. Install the skid control buzzer assembly.



2. INSTALL ECU INTEGRATION BOX RH


    C208064

  1. Install the ECU integration box RH with the nut and bolt.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }

  1. Connect the connectors.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL

HINT:
Perform the same procedure as for the LHD (Click here).



4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Perform the same procedure as for the LHD (Click here).



5. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Perform the same procedure as for the LHD (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



7. INSTALL REAR NO. 3 FLOOR BOARD


    B227791

  1. Engage the 2 guides to install the rear No. 3 floor board.



8. INSTALL REAR DECK FLOOR BOX

  1. Install the rear deck floor box.



9. INSTALL REAR NO. 2 FLOOR BOARD


    B227788E01

  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.