Home

Toyota Workshop

GSIC - Global Service Information Center

OCCUPANT DETECTION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL OCCUPANT DETECTION SENSOR


    B229847

  1. Using hog ring pliers, install 11 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



    B234941

  1. Using hog ring pliers, install the separate type front seat cushion cover to the occupant detection sensor with 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.



2. INSTALL FRONT SEAT CUSHION COVER WITH PAD

HINT:
Use the same procedure described for the LH side (Click here).



3. INSTALL FRONT SEAT CUSHION INNER SHIELD

HINT:
Use the same procedure described for the LH side (Click here).



4. INSTALL FRONT SEAT INNER BELT ASSEMBLY

HINT:
Use the same procedure described for the LH side (Click here).



5. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY

HINT:
Use the same procedure described for the LH side (Click here).



6. INSTALL RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure described for the LH side (Click here).



7. INSTALL FRONT SEAT ASSEMBLY

HINT:
Use the same procedure described for the LH side (Click here).