Home

Toyota Workshop

GSIC - Global Service Information Center

INTELLIGENT PARKING ASSIST SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Thnon-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring disturbed. Reading the Data List information early in troubleshooting one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chass/ Intelligent Parking Assist / Data List.

  5. According to the display on the tester, read the Data List.

    Intelligent Parking Assist 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    AVC-LAN Master Connect Status
    		AVC-LAN communication condition/OK or NG
    		OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    		-
    AVC-LAN Master Reset Status
    		AVC-LAN communication condition/OK or NG
    		OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    		-
    AVC-LAN Master Status
    		AVC-LAN communication condition/OK or NG
    		OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    		-
    AVC-LAN Connect Status
    		AVC-LAN communication condition/OK or NG
    		OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    		-
    AVC-LAN Sending Status
    		AVC-LAN communication condition/OK or NG
    		OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    		-
    AVC-LAN Regist Complete Status
    		AVC-LAN communication condition/OK or NG
    		OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    		-
    AVC-LAN Regist Request Status
    		AVC-LAN communication condition/OK or NG
    		OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    		-
    ON/OFF Parameter Status
    		AVC-LAN communication condition/OK or NG
    		OK: AVC-LAN communication condition normal
    NG: AVC-LAN communication condition abnormal
    		-
    ROM/SUM Check
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    Mirror Check
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    High-Speed RAM Check
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    EEPROM Status (Initial read)
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    RAM Check
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    IG Voltage Low Status
    		IG voltage input to parking assist ECU/OK or NG
    		OK: IG voltage normal
    NG: IG voltage abnormal (too low)
    		-
    IG Voltage High Status
    		IG voltage input to parking assist ECU/OK or NG
    		OK: IG voltage normal
    NG: IG voltage abnormal (too high)
    		-
    ACC Voltage Low Status
    		ACC voltage input to parking assist ECU/OK or NG
    		OK: ACC voltage normal
    NG: ACC voltage abnormal (too low)
    		-
    ACC Voltage High Status
    		ACC voltage input to parking assist ECU/OK or NG
    		OK: ACC voltage normal
    NG: ACC voltage abnormal (too high)
    		-
    CPU Busy Status
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    CPU Communication Status
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    Integer Arithmetic Status
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    FPU Calculation Status
    		Parking assist ECU information/OK or NG
    		OK: Parking assist ECU normal
    NG: Parking assist ECU abnormal
    		-
    AISIC Output Status
    		Output condition of camera display signal/OK or NG
    		OK: Output condition of camera display signal normal
    NG: Output condition of camera display signal abnormal
    		-
    EPS Status
    		EPS (Power Steering System) status/OK or NG
    		OK: EPS available
    NG: EPS not available
    		-
    Wheel Speed Sensor (4wheel)
    		Effectivity of speed signal from speed signal sensor/OK or NG
    		OK: Speed signal effective
    NG: Speed signal not effective
    		-
    Height Sensor Volt Status (L)
    		Power supply for rear height control sensor sub-assembly RH (Low)/OK or NG
    		OK: Power supply for rear height control sensor sub-assembly RH normal
    NG: Power supply for rear height control sensor sub-assembly RH abnormal
    		-
    Height Sensor Volt Status (H)
    		Power supply for rear height control sensor sub-assembly RH (High)/OK or NG
    		OK: Power supply for rear height control sensor sub-assembly RH normal
    NG: Power supply for rear height control sensor sub-assembly RH abnormal
    		-
    Height Sensor Status
    		Vehicle height signal from rear height control sensor sub-assembly RH/OK or NG
    		OK: Signal from rear height control sensor sub-assembly RH normal
    NG: Signal from rear height control sensor sub-assembly RH abnormal
    		-
    Height Sensor Status (Fixing)
    		Vehicle height signal from rear height control sensor sub-assembly RH (Fixing)/OK or NG
    		OK: Rear height control sensor sub-assembly RH normal
    NG: Rear height control sensor sub-assembly RH fixing
    		-
    FLS Sensor Status (Left)
    		No. 1 ultrasonic sensor (front left sensor) condition/OK or NG
    		OK: No. 1 ultrasonic sensor (front left sensor) normal
    NG: No. 1 ultrasonic sensor (front left sensor) abnormal
    		-
    FLS Sensor Status (Right)
    		No. 1 ultrasonic sensor (front right sensor) condition/OK or NG
    		OK: No. 1 ultrasonic sensor (front right sensor) normal
    NG: No. 1 ultrasonic sensor (front right sensor) abnormal
    		-
    Temp Sensor Activate Status
    		Ambient temperature sensor status/valid or invalid
    		OK: Ambient temperature sensor available
    NG: Ambient temperature sensor not available
    		-
    Temp Sensor Status
    		Ambient temperature sensor status/OK or NG
    		OK: Ambient temperature sensor available
    NG: Ambient temperature sensor not available
    		-
    A/C Communication Status
    		Communication condition to air conditioning amplifier assembly/OK or NG
    		OK: Communication condition available
    NG: Communication condition not available
    		-
    Number of DTC
    		Number of stored trouble codes/min.: 0, max.: 255
    		Number of DTCs will be displayed
    		-