Home

Toyota Workshop

GSIC - Global Service Information Center

INTELLIGENT PARKING ASSIST SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


NOTICE:
The following inspection procedure of the intelligent parking assist is described on the assumption that the navigation system is normal. If navigation system has any malfunction, first proceed with troubleshooting of the navigation system.

HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


General 
Symptom
Suspected Area
See page
When reverse (R) has been selected, the intelligent parking assist image is not displayed (navigation display is still displayed).
Proceed to "ECU Power Source Circuit"
Click here
Reverse signal circuit (Navigation System)
Click here
Navigation ECU sub-assembly
Click here
Parking assist ECU
Click here
When reverse (R) has been selected, the intelligent parking assist image is not displayed (screen is black).
Proceed to "Image from Camera for Intelligent Parking Assist is Abnormal"
Click here

Display Malfunction 
Symptom
Suspected Area
See page
Image from camera for the intelligent parking assist is abnormal.
Proceed to "Image from Camera for Intelligent Parking Assist is Abnormal"
Click here
Parking assist ECU
Click here

Switch Malfunction 
Symptom
Suspected Area
See page
The illumination of the parking assist pre support switch assembly does not illuminate.
Parking assist pre support switch assembly inspection
Click here
Harness or connector
-
The touch switches on the navigation ECU sub-assembly display do not operate at all.
Touch SW inspection (Navigation System)
Click here
Navigation ECU sub-assembly
Click here
Parking assist ECU
Click here

Pre Support Function Malfunction 
Symptom
Suspected Area
See page
Pre support function does not operate.
Pre support function operation condition (System Description)
Click here
Signal check (Diagnosis System)
Click here
Parking assist ECU
Click here
When the target parking position is set after pre support operation, the initial display position of the target parking space is very far from the actual parking space.
Pre support function (System Description)
Click here
Notes for ultrasonic sensor (Precaution)
Click here
Ultrasonic sensor
Click here
Front bumper cover
Click here
Parking assist ECU
Click here
"Check IPA System. Have your vehicle checked by a dealer." is displayed on the pre support screen.
Parking assist ECU
Click here
Signal check (Diagnosis system)
Click here
"IPA not available now." is displayed on the pre support screen.
Parking assist ECU
Click here
"IPA not available now." is displayed on the pre support screen though the steering angle neutral point has been corrected.
Spiral cable with sensor sub-assembly
Click here
Steering angle setting (Diagnosis System)
Click here
Parking assist ECU
Click here

Intelligent Parking Assist Function Malfunction 
Symptom
Suspected Area
See page
The vehicle width extension lines do not overlap with the predicted path lines when the steering wheel is centered.
Check the installation of steering wheel
-
Steering angle setting (Diagnosis System)
Click here
Check the installation of rear television camera assembly
Click here
Height control sensor vehicle height difference setting
Click here
Rear television camera optical axis adjustment
Click here
Parking assist ECU
Click here
The predicted path lines stop before the steering wheel is turned to the lock position.
Steering angle setting (Diagnosis System)
Click here
"Check IPA System. Have your vehicle checked by a dealer." is displayed on the intelligent parking assist screen.
Parking assist ECU
Click here
Projected course guide lines are not displayed on the intelligent parking assist screen.
Parking assist ECU
Click here
"System initializing." is displayed.
Correct the steering angle neutral point
Click here
"System initializing." is displayed though the steering angle neutral point has been corrected.
Spiral cable with sensor sub-assembly
Click here
Steering angle setting (Diagnosis System)
Click here
Parking assist ECU
Click here
"System not ready." is displayed.
Parking assist ECU initialization
Click here
"System not ready." is displayed though the parking assist ECU initialization has been performed.
Parking assist ECU
Click here
Assist operation stops frequently ("System cannot assist under current conditions." is displayed).
Inspect the tires (tire size, tire pressure, tire wear)
-
Parking assist ECU
Click here
Assist operation stops frequently ("Use on flat surface." is displayed).
Parking assist ECU
Click here
The set parking position and actual parking position are misaligned either to the right or left in parallel parking mode.
Parallel parking offset (Diagnosis System)
Click here
A rear bumper edge and a bumper reference line swerve at the intelligent parking assist screen.
Check the installation of the rear television camera assembly
Click here
Height control sensor vehicle height difference setting
Click here
Rear television camera optical axis adjustment
Click here
Parts of the bumper reference line are not displayed.
Height control sensor vehicle height difference setting
Click here
Rear television camera optical axis adjustment
Click here
The vehicle does not move to the set parking position.
Vehicle does not move to set parking position
Click here
When the target parking position is set, the initial display position of the target parking space is very far from the actual parking position.
Notes for ultrasonic sensor (Precaution)
Click here
Ultrasonic sensor
Click here
Front bumper cover
Click here
Parking assist ECU
Click here
"CHK" message(s) are displayed on the SIGNAL CHECK screen.
"CHK" message(s) are displayed on the SIGNAL CHECK screen
Click here
A back door open warning message is displayed even after the back door is closed.
"Message indicating back door is open is displayed even after back door is closed"
Click here

Guide Voice Malfunction 
Symptom
Suspected Area
See page
The guide voice for the intelligent parking assist system is inaudible or too quiet (the voice for the navigation system is normal).
Check DTCs (Navigation System)
Click here
Parking assist ECU
Click here
Navigation ECU sub-assembly
Click here