Home

Toyota Workshop

GSIC - Global Service Information Center

METER / GAUGE SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG) and turn the intelligent tester on.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Trouble Codes.

  5. Check for DTCs.


CLEAR DTC

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG) and turn the intelligent tester on.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Trouble Code.

  5. Clear the DTCs.