REAR DOOR COURTESY SWITCH > INSPECTION

for Preparation Click here

1. Measure the resistance according to the value(s) in the table below.
   

   Standard Resistance:

   Tester Connection	Switch Condition	Specified Condition
   1 - Switch body	Pushed	10 kΩ or higher
   1 - Switch body	Not pushed	Below 1 Ω

   Text in Illustration 

   *1	Component without harness connected (Rear Door Courtesy Light Switch Assembly)
   *2	Switch Body

   If the result is not as specified, replace the rear door courtesy light switch assembly.