Home

Toyota Workshop

GSIC - Global Service Information Center

CLOCK SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Clock 
Symptom
Suspected Area
See page
Clock does not operate at all.
Fuse (ECU-B, GAUGE)
-
Wire Harness or Connector
-
Combination Meter Assembly (No. 3 Meter Circuit Plate)
Click here
Clock display illumination malfunction
PANEL Fuse
-
Wire Harness or Connector
-
Combination Meter Assembly (No. 3 Meter Circuit Plate)
Click here
Clock loses or gains time.
Combination Meter Assembly (No. 3 Meter Circuit Plate)
Click here
Clock cannot be adjusted.
Trip Switch
Click here
Wire Harness or Connector
-
Combination Meter Assembly (No. 3 Meter Circuit Plate)
Click here