Home

Toyota Workshop

GSIC - Global Service Information Center

AIR CONDITIONING SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Air Conditioning System 
Symptom
Suspected Area
See page
All functions of the A/C system do not operate
IG power source circuit
Click here
Back-up power source circuit
Click here
Air conditioning control panel circuit
Click here
A/C amplifier
Click here
Air flow control: No blower operation
Blower motor circuit
Click here
Air conditioning control panel circuit
Click here
A/C amplifier
Click here
Air flow control: No blower control
Blower motor circuit
Click here
Air conditioning control panel circuit
Click here
A/C amplifier
Click here
Air flow control: Insufficient air flow
Blower motor circuit
Click here
A/C amplifier
Click here
The blower motor operates by itself or the motor speed changes arbitrarily (Speed does not change in accordance with automatic or manual control settings)*1
IG signal circuit
Click here
Solar ventilation ECU
Click here
Temperature control: No cool air comes out
Refrigerant volume
Click here
Refrigerant pressure
Click here
Air conditioning pressure sensor circuit
Click here
Air mix damper control servo motor circuit
Click here
Evaporator temperature sensor circuit
Click here
Room temperature sensor circuit
Click here
Ambient temperature sensor circuit
Click here
Air conditioning control panel circuit
Click here
Expansion valve
Click here
CAN communication system
Click here
A/C amplifier
Click here
No. 2 engine wire
Click here
Compressor with motor assembly
Click here
Power management control ECU
Click here
Temperature control: No warm air comes out
Air mix damper control servo motor circuit
Click here
Evaporator temperature sensor circuit
Click here
Room temperature sensor circuit
Click here
Ambient temperature sensor circuit
Click here
Air conditioning control panel circuit
Click here
PTC heater circuit*2
Click here
CAN communication system
Click here
Radiator unit sub-assembly
Click here
A/C amplifier
Click here
ECM
Click here
Temperature control: Output air is warmer or cooler than the set temperature or response is slow
Refrigerant volume
Click here
Refrigerant pressure
Click here
Solar sensor circuit
Click here
Room temperature sensor circuit
Click here
Ambient temperature sensor circuit
Click here
Evaporator temperature sensor circuit
Click here
Air mix damper control servo motor circuit
Click here
Air inlet damper control servo motor circuit
Click here
PTC heater circuit*2
Click here
Air conditioning control panel circuit
Click here
Radiator unit sub-assembly
Click here
Expansion valve
Click here
CAN communication system
Click here
A/C amplifier
Click here
No. 2 engine wire
Click here
Compressor with motor assembly
Click here
ECM
Click here
Power management control ECU
Click here
Temperature control: No temperature control (only Max. cool or Max. warm)
Air mix damper control servo motor circuit
Click here
Room temperature sensor circuit
Click here
Ambient temperature sensor circuit
Click here
Evaporator temperature sensor circuit
Click here
Solar sensor circuit
Click here
Air conditioning control panel circuit
Click here
A/C amplifier
Click here
No air inlet control
Air inlet damper control servo motor circuit
Click here
Air conditioning control panel circuit
Click here
A/C amplifier
Click here
No air flow mode control
Air outlet damper control servo motor circuit
Click here
Air conditioning control panel circuit
Click here
A/C amplifier
Click here
Heater performance is low (engine is stopped)*2
PTC heater circuit
Click here
A/C amplifier
Click here
ECO MODE switch indicator does not come on (ECO MODE switch does not operate)
ECO switch circuit
Click here
A/C amplifier
Click here
Pollen removal mode does not operate (A/C system is operating normally)
Air inlet damper control servo motor circuit
Click here
Air outlet damper control servo motor circuit
Click here
Blower motor circuit
Click here
Air conditioning control panel circuit
Click here
A/C amplifier
Click here
Unable to control A/C with the steering pad switch
Steering pad switch circuit
Click here
Air conditioning control panel circuit
Click here
A/C amplifier
Click here
Diagnostic trouble codes (DTCs) are not recorded. Set mode is cleared when power switch is off.
Back-up power source circuit
Click here
A/C amplifier
Click here

Remote Air Conditioning System*3 
Symptom
Suspected Area
See page
The remote air conditioning system does not operate when the remote A/C switch on the key (electrical transmitter) is pressed.
Wireless door lock control system
Click here
Data List (FL Door Courtesy, FR Door Courtesy, RL Door Courtesy SW, RR Door Courtesy SW, Back Door Courtesy SW)
Click here
Data List (Hood Courtesy SW)
Click here
Data List (Start Switch1, Start Switch2)
Click here
Data List (IG SW, ACC SW)
Click here
Data List (FL Door Lock Pos, FR Door Lock Pos, RL-Door Lock Pos SW, RR-Door Lock Pos SW)
Click here
Theft deterrent system
Click here
Operation check (key (electrical transmitter))
Click here
Use simulation method to check
Click here
The remote air conditioning system does not operate even though a wireless door lock is performed when the remote A/C switch on the key (electrical transmitter) is pressed.
Data List (FL Door Courtesy, FR Door Courtesy, RL Door Courtesy SW, RR Door Courtesy SW, Back Door Courtesy SW)
Click here
Data List (Hood Courtesy SW)
Click here
Data List (Start Switch1, Start Switch2)
Click here
Data List (IG SW, ACC SW)
Click here
Data List (Stop Light Switch)
Click here
Data List (Shift Position)
Click here
Theft deterrent system
Click here
Use simulation method to check
Click here
The remote air conditioning system stops operating shortly after the system starts.
Operation check
Click here
Use simulation method to check
Click here
The remote air conditioning system starts operating by itself.
Use simulation method to check
Click here
Operation check (activation control, stop control, key (electrical transmitter))
Click here
Certification ECU
-
A/C amplifier
Click here
Power management control ECU
Click here
The remote air conditioning system cannot be stopped using the remote A/C switch on the key (electrical transmitter).
Customize (Stop Pre A/C)
Click here
Operation check (stop control, key (electrical transmitter))
Click here
A/C amplifier
Click here
Power management control ECU
Click here
Certification ECU
-
  1. *1: w/ Solar Ventilation System
  2. *2: w/ PTC Heater Assembly
  3. *3: w/ Remote Air Conditioning System