Home

Toyota Workshop

GSIC - Global Service Information Center

POWER DOOR LOCK CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the power door lock control system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points for problem analysis:

        What
        		Vehicle model, system name
        When
        		Date, time, occurrence frequency
        Where
        		Road conditions
        Under what conditions?
        		Running conditions, driving conditions, weather conditions
        How did it happen?
        		Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage with the power switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.SYSTEM CHECK

    1. Check the vehicle specification.

      Result:
      Result
      		Proceed to
      w/ Entry System Back Door Open Function
      		A
      w/o Entry System Back Door Open Function
      		B



    		B.
    Go to step 6
    A


    5.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result:
      Result
      		Proceed to
      DTC is not output
      		A
      DTC is output
      		B



    		B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    6.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*

    1. Use the intelligent tester to check if the LIN communication system is functioning normally (Click here).

      Result:
      Result
      		Proceed to
      DTC is not output
      		A
      DTC is output
      		B



    		B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    7.CHECK FOR DTC (MASTER SWITCH)*

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs.

      Result:
      Result
      		Proceed to
      DTC B2312 is not output
      		A
      DTC B2312 is output
      		B



    		B.
    GO TO POWER WINDOW CONTROL SYSTEM (Click here)
    A


    8.PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      		Proceed to
      Fault is not listed in Problem Symptoms Table
      		A
      Fault is listed in Problem Symptoms Table
      		B



    		B.
    Go to step 10
    A


    9.OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)

    3. Operation Check (Click here)


    NEXT


    10.REPAIR OR REPLACE

      NEXT


      11.CONFIRMATION TEST

        NEXT

        END