Home

Toyota Workshop

GSIC - Global Service Information Center

LUMBAR SWITCH (for Manual Seat) > INSTALLATION

for Preparation Click here



1. INSTALL LUMBAR SWITCH


    B229818

  1. Install the lumbar switch with the 2 screws.



2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY


    B229817

  1. Disengage the 5 clamps.

  1. Connect the connector.



    B229815

  1. Engage the clip and 2 claws.

  1. Install the front seat cushion shield assembly with the screw.



3. INSTALL VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)


    B229813

  1. Install the vertical adjusting handle with the screw.



4. INSTALL RECLINING ADJUSTER RELEASE HANDLE


    B231000

  1. Engage the claw and install the reclining adjuster release handle.



5. INSTALL FRONT SEAT ASSEMBLY

  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the connectors under the seat.

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B229808E01

  1. Tighten the 2 bolts on the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.



    B229807E01

  1. Tighten the 2 bolts on the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.



6. INSTALL INNER SEAT TRACK COVER


    B229803

  1. Engage the claw and guide and install the inner seat track cover.



7. INSTALL OUTER SEAT TRACK COVER


    B229805

  1. Engage the 2 claws and install the outer seat track cover.



8. INSTALL FRONT SEAT HEADREST ASSEMBLY


    B229802

  1. Install the front seat headrest assembly as shown in the illustration.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



10. INSTALL REAR NO. 3 FLOOR BOARD


    B227791

  1. Engage the 2 guides to install the rear No. 3 floor board.



11. INSTALL REAR DECK FLOOR BOX

  1. Install the rear deck floor box.



12. INSTALL REAR NO. 2 FLOOR BOARD


    B227788E01

  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



13. INSPECT FRONT SEAT ASSEMBLY

  1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
    If the seat adjusters do not lock simultaneously, loosen the seat mounting bolts to adjust the adjuster position.

  1. w/ Seat Heater Seat System:
    Check the seat heater operation.

    1. Turn the power switch on (IG).

    2. Push the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.



14. INSPECT SRS WARNING LIGHT

HINT:
Inspect the SRS warning light (Click here).