FRONT SEAT ASSEMBLY (for Manual Seat) > INSTALLATION

for Preparation Click here

1. Place the front seat assembly in the cabin.
   

   NOTICE:

   Be careful not to damage the vehicle body.

2. Connect the connectors under the seat.
   

3. Temporarily install the front seat assembly with the 4 bolts.
   

4. Lift up the seat track adjusting handle and move the seat to the rearmost position.
   

5. Tighten the 2 bolts on the front side of the seat.
   

   Torque:

   37 N*m{ 377 kgf*cm , 27 ft.*lbf }

   HINT:

   Tighten the bolts in the order indicated in the illustration.

6. Lift up the seat track adjusting handle and move the seat to the foremost position.
   

7. Tighten the 2 bolts on the rear side of the seat.
   

   Torque:

   37 N*m{ 377 kgf*cm , 27 ft.*lbf }

   HINT:

   Tighten the bolts in the order indicated in the illustration.

1. Engage the claw and guide and install the inner seat track cover.
   

1. Engage the 2 claws and install the outer seat track cover.
   

1. Install the front seat headrest assembly as shown in the illustration.
   

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

1. Engage the 2 guides to install the rear No. 3 floor board.
   

1. Install the rear deck floor box.
   

1. Engage the 3 guides <A>.
   

2. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
   

1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
   If the seat adjusters do not lock simultaneously, loosen the seat mounting bolts to adjust the adjuster position.
   

2. w/ Seat Heater Seat System:
   Check the seat heater operation.
   
   

   1. Turn the power switch on (IG).
      

   2. Push the seat heater switch on.
      

   3. Wait 5 minutes or more and confirm that the seat surface becomes warm.
      

HINT:

Inspect the SRS warning light (Click here).