Home

Toyota Workshop

GSIC - Global Service Information Center

AIRBAG SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here


HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY

  1. Turn the power switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the intelligent tester on.

  5. Enter the following menus: Body / SRS Airbag / Data List.

  6. Check the values by referring to the table below.

    SRS Airbag 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Display Type Information
    		Display Type Information/
    LR: The display is indicated by LH/RH
    DP: The display is indicated by Driver/Passenger
    		LR
    		-
    Number of Past DTC
    		Number of Past DTC/
    Min.: 0, Max.: 255
    		0
    		-