AIRBAG SYSTEM > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here

HINT:

1. When the SRS warning light remains on and the DTC output is the normal system code, a voltage source drop is likely to occur. This malfunction is not stored in the memory by the center airbag sensor assembly. If the power source voltage returns to normal, the SRS warning light will automatically go off.
   
2. When 2 or more codes are indicated, the code with the lower number appears first.
   
3. If a code is not listed on the display chart, the center airbag sensor assembly may have failed.
   
4. In the case of any malfunction concerning an open circuit, short to ground, or short to B+ due to a squib, other trouble codes may not be detected. In this case, repair the malfunction currently indicated and then perform malfunction diagnosis again.
   
5. Mark in the check mode column:
   *1: DTC does not correspond to check mode.
   *2: DTC corresponds to check mode.
   
6. DTC which has the mark of the *3 is output only the equipped car of airbag cut off switch.