LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here

HINT:

The following items can be customized.

NOTICE:

1. When the customer requests a change in a function, first make sure that the function can be customized.
   
2. Be sure to make a note of the current settings before customizing.
   
3. When troubleshooting a function, first make sure that the function is set to the default setting.
   

1. Connect the intelligent tester to the DLC3.
   

2. Turn the power switch on (IG).
   

3. Turn the intelligent tester on.
   

4. Enter the following menus: Customize Setting / Light Control.
   

5. Select the setting by referring to the table below.
   
   

   Light Control 

   Display	Default	Content	Setting
   Disp Ex ON Sen	Normal	Changes the ambient brightness level required to dim the lights such as the indicator lights of the combination meter, A/C indicator light and clock.	Light2, Light1, Normal, Dark1 or Dark2
   Disp Ex OFF Sen	Normal	Changes the ambient brightness level required to cancel the dimming of the lights such as the indicator lights of the combination meter, A/C indicator light and clock.	Light2, Light1, Normal, Dark1 or Dark2
   Response Time	0.1 s	Changes the delay timing of lighting the taillights when going into a tunnel when the light control switch is in the AUTO position	0.1 s or 1.0 s
   Sensitivity	Normal	Adjusts the sensitivity of the automatic light control system.	Light2, Light1, Normal, Dark1 or Dark2
   DRL Function	On	ON/OFF of the DRL function	On or Off