Home

Toyota Workshop

GSIC - Global Service Information Center

FRONT SEAT ASSEMBLY (for Manual Seat) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

NOTICE:
w/ Navigation System for HDD:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal (Click here).



2. REMOVE REAR NO. 2 FLOOR BOARD


    B227787E01

  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX

  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD


    B227791

  1. Disengage the 2 guides and remove the rear No. 3 floor board.



5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. REMOVE FRONT SEAT HEADREST ASSEMBLY


    B229801

  1. Press the headrest support button and pull up the headrest as shown in the illustration to remove it.



7. REMOVE OUTER SEAT TRACK COVER


    B229805

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. Disengage the 2 claws and remove the outer seat track cover.



8. REMOVE INNER SEAT TRACK COVER

  1. Disengage the claw.



    B229803

  1. Separate the guide and remove the inner seat track cover.



9. REMOVE FRONT SEAT ASSEMBLY


    B229807

  1. Remove the 2 bolts on the rear side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B229808

  1. Remove the 2 bolts on the front side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

  1. Disconnect the connectors under the seat.

  1. Remove the seat.

    NOTICE:
    Be careful not to damage the vehicle body.